Omron CQM1H-SCB41 operation manual Control Sequence No, Appendix M

V600/V620 ID Controller Protocol								Appendix M
	Receive Data Word Allocation (3rd Operand of PMCR)
	Receive data	+0			Number of receive data words
	storage words
		+1			(Undefined)		Completion code
				Offset		Contents (data format)		Data
			+0			Number of receive data		0002 (fixed)
						words (4 digits BCD)
			+1			Completion code		(Verification, calculation designation)
						(2 digits Hexadecimal)		00: Normal completion for calculation processing
								75: Data in normal condition for verification
								processing
								76: Error Data alarm for verification processing
								(If management of number of write times is
								designated)
								75:Number of write times is under those which is
								specified.
								76:alarm for number of write times is over those
								which is specified.

Note If L (management of number of write times) is designated by processing designation, management of num- ber of write times for Data Carrier of EEPROM is performed.

Control (Sequence No. 541)

This sequence performs I/O operations or I/O reads.

Send Data Word Allocation (2nd Operand of PMCR)

First word of send +0		Number of send data words
data
	+1	(Undefined)	Unit No.
	+2	(Undefined)	OUT1 operation	OUT2 operation

Offset	Contents (data format)	Data
+0	Number of send data words	0003 (fixed)
	(4 digits BCD)
+1	Unit No. (2 digits BCD)	00 to 07 (CD1D)
+2	OUT1 operation (1 digit BCD)	0: No operation
		1: turned ON
		2: turned OFF
	OUT2 operation (1 digit BCD)	0: No operation
		1: turned ON
		2: turned OFF

Receive Data Word Allocation (3rd Operand of PMCR)

Receive data	+0	Number of receive data words
storage words
	+1	Current input status	Output status after
			operation

Offset	Contents (data format)		Data
+0	Number of receive data words		0002 (fixed)
	(4 digits BCD)
+1	Current input status		1: ON status
Leftmost 1	Leftmost 4 bits:	IN1 operation	0: OFF status
byte	Rightmost 4 bits:	IN2 operation
	Output status after operation		1: ON status
	Leftmost 4 bits:	OUT1 operation	0: OFF status
	Rightmost 4 bits:	OUT2 operation

Note 1. The V600/620-CAjA does not support this command.

2. This sequence executes the equivalent of the CONTROL command.

399