Omron CQM1H-SCB41 Board Identification Error Flag hardware error, Protocol Data Error Flag

Using Protocol MacrosSection 5-6

5-6	Control Bits, Flags, and Status Information
		Control bits, flags, and status information for the Serial Communications Board
		are available in the Inner Board Slot 1 area. The addresses in this area are as
		follows:
		Inner Board Slot 1 Area: IR 200 to IR 207
		All of the bits in the following table are initialized (cleared) when power to the PC
		is turned ON, when the mode is changed between PROGRAM and RUN/MON-
		ITOR mode, when the STUP(––) instruction is executed to change the serial
		communications mode, or when the communications port is restarted. The bits
		are also reset at the timing indicated in the Reset column in the table.
Word	Bits	Name and Function	Classifi-	Set	Reset
			cation
IR 200	00	Serial Communications Board Hardware Error Flag	System	When error	Power ON
		Turns ON if an error occurs in the Board. Replace the	error	occurs
		Board if this flag will not turn OFF even after remounting
		the Board securely or mounting it in a different CPU Unit.
	01	Board Identification Error Flag (hardware error)
		Replace the Board if this flag turns ON.
	02	Protocol Data Error Flag			Normal
		This flag turns ON if an error is detected in the protocol			completion
					of protocol
		data checksum when the power is turned ON. The ERR
					data
		indicator on the CPU Unit will also flash and the RDY indi-
					transfer
		cator will flash.
		This error may occur if the communications connector be-
		comes disconnected or the PC power is turned OFF dur-
		ing protocol data transfer. Use the CX-Protocol to transfer
		of the protocol data again.
	11	Port 2 Protocol Macro Execution Error Flag			Start of
		The flag turns ON when the protocol macros are not			sequence
		supported (error code 1), there is a sequence number
		error (error code 2), an attempt was made to write data
		receive data at an illegal address (error code 3), or a
		protocol data syntax error occurred (error code 4).
	12	Port 1 Protocol Macro Execution Error Flag
		Same as IR 20011.
	13	PC Setup Error Flags			Power ON
		Bit 15 turns ON if a Setup error occurs in the PC Setup
		settings for the Board.
	14
		Bit 14 will turn ON if the error is for port 1.
		Bit 13 will turn ON if the error is for port 2.
	15	Correct the PC Setup.
		The defaults will be used for the settings causing th error.

80