Configuring System Information 111
Defining SNTP Servers Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the SNTP
Server page.
The following is an example of the CLI commands:
Defining SNTP Interfaces
The SNTP Broadcast Interface Table page contains SNTP interface information. To open the SNTP
Broadcast Interface Table page, click System → SNTP → Interface Settings.
Figure 6-17. SNTP Broadcast Interface Table
Table 6-11. SNTP Server CLI Commands
CLI Command Description
sntp server ipv4-address|ipv6-
address|hostname [poll] [key keyid]
Configures the device to use SNTP to request and accept SNTP
traffic from a server.
Console(config)# sntp server 100.1.1.1 poll key 10