Enabling IGMP Snooping on the device
1Open the Global Parameters page.
2Select Enable in the IGMP Snooping Status field.
3Click Apply Changes.
IGMP Snooping is enabled on the device.
Enabling Multicast Filtering and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling Multicast Filtering and IGMP Snooping as displayed on the Global Parameters page.
Table
CLI Command | Description |
|
|
bridge multicast filtering | Enables filtering of Multicast addresses. |
|
|
ip igmp snooping | Enables Internet Group Membership |
| Protocol (IGMP) snooping. |
|
|
The following is an example of the CLI commands:
console(config)# bridge multicast filtering
console(config)# ip igmp snooping
Adding Bridge Multicast Address Members
The Bridge Multicast Group page displays the ports and LAGs attached to the Multicast service group in the Ports and LAGs tables. The Port and LAG tables also reflect the manner in which the port or LAGs joined the Multicast group. Ports can be added either to existing groups or to new Multicast service groups. The Bridge Multicast Group page permits new Multicast service groups to be created. The Bridge Multicast Group page also assigns ports to a specific Multicast service address group.
To open the Bridge Multicast Group page, click Switch → Multicast Support → Bridge Multicast Group in the tree view.
Configuring Switch Information
389
