Erase FLASH File - option[2]
In some cases, the device configuration must be erased. If the configuration is erased, all parameters configured via CLI, EWS or SNMP must be reconfigured.
To erase the device configuration:
1From the Startup menu, press [2] within two seconds to erase flash file. The following message is displayed:
Warning! About to erase a Flash file. Are you sure (Y/N)? y
2Press Y. The following message is displayed.
Write Flash file name (Up to 8 characters, Enter for none.):config File config (if present) will be erased after system initialization
======== Press Enter To Continue ========
3Enter config as the name of the flash file. The configuration is erased and the device reboots.
4Repeat the device initial configuration.
Password Recovery - option[3]
If a password is lost, the Password Recovery procedure can be called from the Startup menu. The procedure enables entry to the device once without password.
To recover a lost password when entering the local terminal only:
1From the Startup menu, type [3] and press <Enter>. The password is deleted. Enter your choice or press ESC to exit
Current password will be ignored!
NOTE: To ensure device security, reconfigure passwords for applicable management methods.
Enter Diagnostic Mode - option[4]
For Technical Support only.
Set Terminal
To set the terminal
Enter your choice or press 'ESC' to exit:
Set new device baud-rate: 38,400
62
