4Select a table entry.

5Select the Remove check box.

6Click Apply Changes.

The selected static address is deleted, and the device is updated.

Configuring Static Address Parameters Using CLI Commands

The following table summarizes the equivalent CLI commands for configuring static address parameters as displayed in the Static MAC Address page.

Table 7-16. Static Address CLI Commands

CLI Command

Description

 

 

bridge address mac-address[permanent delete-on-

Adds a static MAC-layer station source address to the

reset delete-on-timeout secure] {ethernet interface

bridge table.

port-channelport-channel-number}

 

show bridge address-table [vlan vlan] [ethernet interface port-channel port-channel-number]

Displays entries in the bridge-forwarding database.

The following is an example of the CLI commands.

console(config-if)#bridge address 00:60:70:4C:73:FF permanent ethernet g8

console# show bridge address-table

Aging time is 300 sec

vlan

mac address

port

type

----

------------

----

--------

1

00:60:70:4C:73:FF

1/e8

dynamic

1

00:60:70:8C:73:FF

1/e8

dynamic

200

00:10:0D:48:37:FF

1/e9

static

Viewing Dynamic Addresses

The Dynamic Address Table contains information for querying information in the dynamic address table, including the interface type, MAC addresses, VLAN, and table sorting. Packets forwarded to an address stored in the address table are forwarded directly to those ports. The Dynamic Address Table page also contains information about the aging time before a dynamic MAC address is erased, and includes parameters for querying and viewing the Dynamic Address list. The Current Address Table contains dynamic address parameters by which packets are directly forwarded to the ports.

318

Configuring Switch Information

Page 318
Image 318
Dell 3548 manual Console# show bridge address-table, Viewing Dynamic Addresses