3Set the data rate to 9600 baud.
4Set the data format to 8 data bits, 1 stop bit, and no parity.
5Set flow control to none.
6Under Properties, select VT100 for Emulation mode.
7Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that the setting is for Terminal keys (not Windows keys).
CAUTION: When using HyperTerminal with Microsoft® Windows® 2000,ensure that you have Windows 2000 Service Pack 2 or later installed. With Windows 2000 Service Pack 2, the arrow keys function properly in HyperTerminal’s VT100 emulation. Go to www.microsoft.com for information on Windows 2000 service packs.
8Connect the female connector of the
Figure 3-7. Connecting to PowerConnect 35xx Series Systems Console Port
Back Panel
To VT100
Terminal
NOTE: A console can be connected to the Console port on any unit in the stack, but stack management is performed only from the stack master (unit ID 1 or 2).
48
