Defining IPv6 ISATAP Tunnel Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the IPv6 ISATAP Tunnel page.
Table
CLI Command | Description |
interface tunnel number Enters tunnel interface configuration mode.
tunnel mode ipv6ip {isatap} Configures an IPv6 transition mechanism global support mode.
tunnel isatap router | Configures a global string that represents a |
router_name | specific automatic tunnel router domain name. |
|
|
tunnel source { auto ip- | Sets the local (source) IPv4 address of a tunnel |
address | interface. |
interface } |
|
|
|
tunnel isatap | Configures the interval between DNS Queries |
seconds | (before the IP address of the ISATAP router is |
| known) for the automatic tunnel router domain |
| name. |
|
|
tunnel isatap solicitation- | Configures the interval between ISATAP router |
interval seconds | solicitations messages (when there is no active |
| ISATAP router). |
|
|
tunnel isatap robustness | Configure the number of DNS Query / Router |
number | Solicitation refresh messages that the device |
| sends. |
|
|
show ipv6 tunnel | Displays information on the ISATAP tunnel. |
|
|
The following is an example of the CLI commands:
Console> show ipv6 tunnel
Router DNS name: ISATAP
Router IPv4 address: 172.16.1.1
DNS Query interval: 10 seconds
Min DNS Query interval: 0 seconds
Router Solicitation interval: 10 seconds
Min Router Solicitation interval: 0 seconds
Robustness: 3
Configuring System Information
147
