Dell 3548 manual Configuring Lldp Using CLI Commands, Defining Lldp Port Settings

Configuring LLDP Using CLI Commands

Table 6-43. LLDP Properties CLI Commands

CLI Command	Description
lldp enable (global)	Enables enable Link Layer Discovery Protocol.
lldp hold-multiplier	Specifies the time that the receiving device should
number	hold a Link Layer Discovery Protocol (LLDP) packet
	before discarding it.

lldp reinit-delaySeconds Specifies the minimum time an LLDP port will wait before reinitializing.

lldp tx-delaySeconds Specifies the delay between successive LLDP frame

tr.ansmissions.

The following is an example of the CLI commands:

Console(config)# interface ethernet g1

Console(config-if)# lldp enable

Defining LLDP Port Settings

The LLDP Port Settings page allows network administrators to define LLDP port settings, including the port number, the LLDP port number, and the type of port information advertised.

The Port Settings page contains fields for configuring LLDP. To open the Port Settings page, click System → LLDP-MED → Port Settings in the tree view.

208

Configuring System Information