Displaying Protocols Assigned to Ports

1Open the Protocol Port page.

2Click Show All.

The Protocol Based VLAN Table opens.

Figure 7-59. Protocol Based VLAN Table

Defining Protocol Ports Using CLI Commands

The following table summarizes the equivalent CLI command for defining Protocol Ports.

Table 7-31. Protocol Port CLI Commands

CLI Command

Description

switchport general map Sets a protocol-based classification rule. protocols-group group

vlan vlan-id

The following example sets a protocol-based classification rule of protocol group 1 to VLAN 8:

Console (config-if)#switchport general map protocols-group 1 vlan 8

Configuring GVRP Parameters

GARP VLAN Registration Protocol (GVRP) is specifically provided for automatic distribution of VLAN membership information among VLAN-aware bridges. GVRP allows VLAN-aware bridges to automatically learn VLANs to bridge ports mapping, without having to individually configure each bridge and register VLAN membership.

To ensure the correct operation of the GVRP protocol, it is advised to set the maximum number of GVRP VLANs equal to a value which significantly exceeds the sum of:

The number of all static VLANs both currently configured and expected to be configured.

The number of all dynamic VLANs participating in GVRP, both currently configured (initial number of dynamic GVRP VLANs is 128) and expected to be configured.

Configuring Switch Information

369

Page 369
Image 369
Dell 3548 manual Configuring Gvrp Parameters, Protocol Based Vlan Table