4Check the Copy to check box to define the interfaces to which the storm control definitions are copied, or click Select All to copy the definitions to all ports.

5Click Apply Changes.

The parameters are copied to the selected ports in the Storm Control Settings Table, and the device is updated.

Configuring Storm Control with CLI Commands

The following table summarizes the equivalent CLI commands for configuring Storm Control as displayed on the Storm Control page.

Table 7-14. Storm Control CLI Commands

CLI CommandDescription

port storm-control

include-multicast

Enables the device to count Multicast,

 

 

 

 

Unicast, and Broadcast packets together.

 

 

 

port storm-control broadcast

enable

Enables broadcast storm control.

 

 

 

 

port

storm-control broadcast

rate

Configures the maximum broadcast rate.

 

 

 

show

ports storm-control port

Displays the storm control configuration.

 

 

 

 

 

The following is an example of the CLI commands:

console(config)# port storm-control include-multicast console(config)# interface ethernet 1/e1 console(config-if)#port storm-control broadcast enable console(config-if)#port storm-control broadcast rate 100000 console(config-if)#end

console# show ports storm-control

Port

Broadcast Storm control [kbyes/sec]

-----

-------------------------------------

1/e1

8000

2/e1

Disabled

3/e2

Disabled

Configuring Switch Information

311

Page 311
Image 311
Dell 3548 manual Port storm-control Include-multicast