23. Frequency Response, HP 8596EM

Figure 2-32. Frequency Response Test Setup, <50 MHz, HP 8596EM

Frequency Response, Band 0, <50 MHz

33. Set the synthesizer/level generator controls as follows:

FREQUENCY : : : : : : : : : : : : : : :: : : : :: : : :: : : : :: : : : : :: : :: : : : : : : : : 50 MHz

AMPLITUDE : : : : : : :: : :: : : : : : : : : : :: : : : : : : : : : : : : : : : : : : : : : : :: : 08 dBm

AMPTD INCR : : :: : : : : :: : :: : : : : : : : : :: : : : :: : : :: : :: : : : : : : : : : :: : 0.05 dB

34.Connect the equipment as shown if Figure 2-32, with the power sensor connected to power splitter.

35.On the EMC analyzer, press the following keys:

4MKR5 MARKER 1 ON OFF (OFF)

4FREQUENCY5 More 1 of 2 Band Lock BND LOCK ON OFF (OFF)

4FREQUENCY5 50 4MHz5

4SPAN5 10 4MHz5

4MKR !5 MARKER ! HIGH

4MKR5 More 1 of 3 MKR TRACK ON OFF (ON)

4SPAN5 100 4kHz5

4BW5 IF BW AUTO MAN (MAN) 10 4kHz5

36.Enter the power sensor 50 MHz Cal Factor into the measuring receiver.

37.Adjust the synthesizer/level generator amplitude until the measuring receiver display reads the same value as recorded in step 11. Record the synthesizer/level generator amplitude in Table 2-41.

2-146 Performance Veri￿cation Tests