38. Gain Compression, HP 8596EM

Figure 2-60. Gain Compression Test Setup, HP 8596EM

Procedure

Gain Compression, <2.9 GHz

1.Zero and calibrate the measuring receiver and 50 MHz to 12.8 GHz power sensor combination in log mode (power reads out in dBm) as described in the measuring receiver operation manual. Enter the power sensor 2 GHz Cal Factor into the measuring receiver.

2.Connect the equipment as shown in Figure 2-60, with the output of the directional coupler connected to the power sensor.

3.Press INSTRUMENT PRESET on both synthesized sweepers.

4.Set synthesized sweeper #1 controls as follows:

CW : : : : : : : : : : :: : : : : : : : : : : : :: : : : : : : : : : : : : : : : : : : : : : : : :: : : : : : : : : : : : : : : 2.003 GHz

POWER LEVEL : : : : : : : : : : : : : : : : : : : : : : :: : : : : : : : : : : : : : : : : : : : : : : : :: : : : : : : 0 dBm

5. Set synthesized sweeper #2 controls as follows:

CW :: :: :: :: :: ::: :: :: :: ::: :: :: :: :: ::: :: :: : : ::: :: :: :: :: ::: :: :: :: ::: : : :: 2.0 GHz

AMPLITUDE ::: :: :: :: ::: :: : : :: :: ::: :: :: :: ::: :: :: :: :: ::: :: :: :: ::: :: : 014 dBm

2-260 Performance Veri￿cation Tests