36. Gain Compression, HP 8594EM

Figure 2-58. Gain Compression Test Setup, HP 8594EM

Procedure

Gain Compression, <2.9 GHz

1.Zero and calibrate the measuring receiver and the power sensor combination in log mode (power reads out in dBm) as described in the measuring receiver operation manual. Enter the power sensor 2 GHz Cal Factor into the measuring receiver.

2.Connect the equipment as shown in Figure 2-58, with the output of the directional coupler connected to the power sensor.

3.Press INSTRUMENT PRESET on both synthesized sweepers.

4.Set synthesized sweeper #1 controls as follows:

CW : : : : : : : : : : :: : : : : : : : : : : : : : : : : : : : : : : : :: : : : : : : : : : : : :: : : : : : : : : : : : : : : 2.003 GHz

POWER LEVEL : : : : : : : : : : :: : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : :: : : : : : : 0 dBm

5. Set synthesized sweeper #2 controls as follows:

CW :: :: ::: :: :: :: ::: :: :: :: ::: :: :: :: :: ::: :: :: :: ::: :: :: :: :: ::: :: :: :: : :: : 2.0 GHz

AMPLITUDE : :: ::: :: :: :: ::: :: :: :: :: ::: :: :: :: ::: :: :: : : :: ::: :: :: :: ::: 014 dBm

Performance Veri￿cation Tests 2-249