8. Frequency Span Readout Accuracy, HP 8591EM

Procedure

This performance veri￿cation test consists of two parts:

Part 1: 1800 MHz Frequency Span Readout Accuracy

Part 2: 10.1 MHz to 10 kHz Frequency Span Readout Accuracy

Perform \Part 1: 1800 MHz Frequency Span Readout Accuracy" before

performing \Part 2: 10.1 MHz to 10 kHz Frequency Span Readout Accuracy."

Part 1: 1800 MHz Frequency Span Readout A ccuracy

1.Connect the equipment as shown in Figure 2-8. Note that the power splitter is used as a combiner.

2.Press 4PRESET5 on the EMC analyzer, then wait for the preset routine to ￿nish.

3.Press INSTRUMENT PRESET on the synthesized sweeper and set the controls as follows:

CW : : : : : : : : : : : : : : : : : : :: : : : : : : : :: : : : :: : : :: : : : :: : : : : : : : :: : : : : :1700 MHz

POWER LEVEL : : :: : : :: : : :: : : : : : : : : : : : : : : : : : : :: : : : :: : : :: : : : : 05 dBm

4. On the signal generator, set the controls as follows:

FREQUENCY (LOCKED MODE) : : : : :: : : : : : : : : : : : : : : : : : :: : : : 200 MHz

CW OUTPUT : : : : : : : : : : : : : : :: : : : : : : : : : : : : :: : : :: : : : :: : : : : :: :: : : : 0 dBm

5.Adjust the EMC analyzer center frequency, if necessary, to place the lower frequency on the second vertical graticule line (one division from the left-most graticule line).

6.On the EMC analyzer, press 4SGL SWP5. Wait for the completion of a new sweep, then press the following keys:

4MKR !5 MARKER ! HIGH

More 1 of 3 More 2 of 3 MARKER 1

More 3 of 3 NEXT PEAK

The two markers should be on the signals near the second and tenth vertical graticule lines (the ￿rst graticule line is the left-most).

Performance Veri￿cation Tests 2-33