System Settings
Tray for Printing Incoming Faxes
Specifies the trays for incoming faxes. You can select one or more trays except Tray 5 (Bypass). If the trays selected here run out of paper, Tray 5 (Bypass) is used.
2 Pages Up On Receipt
Specifies whether to print consecutively received two documents onto one page. It is effective in saving paper. If the number of received pages is odd, a blank page will be added at the end. If the sizes of received pages are different, the larger size will be used.
NOTE: If the same size paper as the received document size is available, that paper will be printed even when you set this feature to [Yes].
2 Sided Printing
Specifies whether to print received documents or private mailbox documents onto both sides of a sheet. This is effective in saving paper.
NOTE: Some data may not allow you to use this feature even when you set it to [On].
Edge Erase - Top & Bottom Edges
Specifies the margin on the top and bottom of the received document by cutting off the original image. You can set the margins within the range of
Edge Erase - Left & Right Edges
Specifies the margin on the left and right of the received document by cutting off the original image. You can set the margins within the range of
Reduce 8.5×11” SEF Original to A4 SEF
Specifies whether a 8.5 × 11.0 inches (216 × 279 mm) size document is to be reduced to the A4 size when [Reduce/Enlarge] in the [Layout Adjustment] screen is set to [Auto %].
Specifies whether to perform gradation level correction for documents containing photographs. Select from [Error Diffusion] and [Dither].
Mailbox Selector Setup
Specifies whether to sort the received documents to the mailboxes by the incoming line when more than one line is in use.
NOTE: When setting the mailbox selector feature, select a mailbox that has already been registered. If an unregistered mailbox is selected, the received document is automatically printed instead of stored in a mailbox.
Memory Full Procedure
Specifies the default process to execute if the hard disk becomes full while reading documents. A message asking how to process the data read up to that point is displayed. You can predefine a processing method to be performed after the message has been displayed for a specified period. If you select [Cancel Job], the data will be discarded. If you select [Run Job], the data read up to that point will be processed.
113
