Xerox 5222 manual When IPv4 Mode or Dual Stack is selected in step

CentreWare Internet Services Installation

6.Select [Port Settings] in the [Features] menu.

7.Select [Internet Services] and [Change Settings].

8.Select [Port Status] and [Change Settings].

9.Select [Enabled] and [Save].

Set the port number for CentreWare Internet Services, if required.

10.At the [Internet Services] screen, select [Internet Services Port Number] and [Change Settings].

11.Use the keypad to enter the port number, and select [Save].

Next, establish TCP/IP.

1.Select [Connectivity & Network Setup] in the [Group] menu, and then select [Protocol Settings] in the [Features] menu.

2.Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].

When [IPv4 Mode] or [Dual Stack] is selected in step 2

3.Select [IP Address Resolution], and then [Change Settings].

4.Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP], [DHCP/Autonet], and [STATIC], and then select [Save].

NOTE: Use the DHCP server together with the Windows Internet Name Server (WINS) server.

If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocol settings. Otherwise, proceed to step 11.

5.Select [IPv4 - IP Address], and then [Change Settings].

6.Use the keypad on the screen to enter an IP address for the machine in the format “xxx.xxx.xxx.xxx”. When you have finished entering all values, select [Save].

7.Select [IPv4 – Subnet Mask], and then [Change Settings].

8.Using the same method as in step 6, enter a subnet mask.

9.Select [IPv4 – Gateway Address], and then [Change Settings].

10.Using the same method as in step 6, enter a gateway address.

NOTE: If you do not wish to set the gateway address, leave this field blank.

11.Select [IPv4 – IP Filter], and then [Change Settings].

12.Select [Enabled] to filter access to the machine.

NOTE: If you do not wish to use the IP filter feature, select [Disabled].

NOTE: Use CentreWare Internet Services to register the IP addresses which are not allowed to access the machine. Refer to Properties on page 173.

13.When you have finished establishing TCP/IP, select [Close] on the [Protocol Settings] screen.

When [IPv6 Mode] or [Dual Stack] is selected in step 2

3.Set [IPv6 Address Manual Configuration].

NOTE: Select [Enabled] when the machine is connected to a network on which IPv6 stateless address autoconfiguration is disabled, or when you want to set a static IPv6 address.

149