GPIB Command Dictionary

CONFigure subsystem

:OFLevel:RFINout <real number> :OFLevel:RFINout?

These commands set/query the path loss from the RF IN/OUT connector to the device-under-test. This correction is applied when the CONF:OFL:MODE ‘On’ command is used.

This command utilizes the “Real Number Setting Syntax” on page 299, but does not use the :STATe command.

Syntax

CONF:OFL:RFIN <real number> !values: minus 100.0 to 100.0

CONF:OFL:RFIN?

Screen/field equivalent

CONF:OFL:RFIN controls the RF In/Out field of the INSTRUMENT CONFIGURE screen. This value in this field is used when the RF Level Offset field is set to On.

:OFRequency <real number> :OFRequency?

These commands set/query the frequency offset between the Test Set’s generator and analyzer. This command is used only in frequency tuning mode (CONF:RFD ‘Freq’) and RF offset must be turned on (CONF:OMODE ‘On’).

This command utilizes the “Real Number Setting Syntax” on page 299, but does not use the :STATe command.

Syntax

CONF:OFR <real number>

CONF:OFR?

Screen/field equivalent

CONF:OFR controls the (Gen)-(Anl)field of the INSTRUMENT

CONFIGURE screen.

Chapter 1

155

Page 155
Image 155
Agilent Technologies E6380-90073 manual OFLevelRFINout real number OFLevelRFINout?, OFRequency real number OFRequency?