Agilent Technologies E6380-90073 manual NAMPsNTACsFOCCRATE real number NAMPsNTACsFOCCRATE?

GPIB Command Dictionary

AFG2ENCoder subsystem

:NAMPsNTACs[:FOCC]:RATE <real number> :NAMPsNTACs[:FOCC]:RATE?

These commands set/query the data rate of the encoded message.

This command utilizes the “Real Number Setting Syntax” on page 299 but does not use the :STATe command.

Syntax

AFG2:NAMP:FOCC:RATE

AFG2:NAMP:FOCC:RATE?

Screen/field equivalent

AFG2:NAMP[:FOCC]:RATE controls the Data Rate field on the

SIGNALING ENCODER screen when the Mode field is set to

NAMP-NTAC, and the Channel field is set to Cntl.

:NAMPsNTACs[:FOCC]:FILLer:DATA1 <string> :NAMPsNTACs[:FOCC]:FILLer:DATA2 <string> :NAMPsNTACs[:FOCC]:FILLer:DATA1?

:NAMPsNTACs[:FOCC]:FILLer:DATA2?

These commands set/query FOCC filler data. Each filler contains 7 hexadecimal characters representing the 2 type bits and 26 information bits of the control filler/message word. The control filler is sent continuously when the :NAMPsNTACs[:FOCC]:FILL:SEND command is used or after a control message has been sent using :NAMPsNTACs:SEND.

Both filler fields must be full (seven digits) for the forward control channel information to be structured correctly. Do not leave any blank spaces.

To use this command, AFG2:NAMP:CHAN must be set to ‘Cntl’.

Syntax

AFG2:NAMP[:FOCC]:FILL:DATA1 <string>

AFG2:NAMP[:FOCC]:FILL:DATA2 <string>

AFG2:NAMP[:FOCC]:FILL:DATA1?

AFG2:NAMP[:FOCC]:FILL:DATA2?

Screen/field equivalent

AFG2:NAMP[:FOCC]:FILL:DATA1 and DATA 2 control the Filler fields for Stream A and Stream B on the SIGNALING ENCODER screen when the Mode field is set to NAMP-NTAC, and the Channel field is set to Cntl.

Chapter 1 93