GPIB Command Dictionary

AFG2ENCoder subsystem

:NAMPsNTACs:DSAT:MESS <string> :NAMPsNTACs:DSAT:MESS?

These commands set/query the 24-bit digital supervisory audio tone (DSAT) sequence. The seven standard sequences are: 2556CB, 255B2B, 256A9B, 25AD4D, 26AB2B, 26B2AD, and 2969AB. (These codes are the inverse of the seven DST codes.)

DSAT is output continuously when AFG2:NAMP:DSAT:SEND is sent. It is only stopped when AFG2:NAMP:DSAT:STOP is sent, or when the DST message stream is sent.

Syntax

AFG2:NAMP:DSAT:MESS <string>

AFG2:NAMP:DSAT:MESS?

Screen/field equivalent

AFG2:NAMP:DSAT:MESS controls the FVC DSAT field on the

SIGNALING ENCODER screen when the Mode field is set to

NAMP-NTAC, and the Channel field is set to Voice.

:NAMPsNTACs:DSAT:SEND <string> :NAMPsNTACs:DSAT:SEND?

This command set/query sends the 24-bit digital supervisory audio tone (DSAT) sequence. DSAT is output continuously when AFG2:NAMP:DSAT:SEND is sent. It is only stopped when AFG2:NAMP:DSAT:STOP is sent, or when a message or DST is sent. If a message or DST is sent, the DSAT data is output after the message is output.

Syntax

AFG2:NAMP:DSAT:SEND

AFG2:NAMP:DSAT:SEND?

Screen/field equivalent

AFG2:NAMP:DSAT:SEND controls the FVC Send DSAT field on the SIGNALING ENCODER screen when the Mode field is set to NAMP-NTAC, and the Channel field is set to Voice.

90

Chapter 1

Page 90
Image 90
Agilent Technologies E6380-90073 manual NAMPsNTACsDSATMESS string NAMPsNTACsDSATMESS?