Agilent Technologies E6380-90073 manual CDANalyzerTIMEOFFSet meas cmnd CDANalyzerTIMEOFFSet?

GPIB Command Dictionary

MEASure subsystem

:CDANalyzer:TIME:OFFSet <meas cmnd> :CDANalyzer:TIME:OFFSet?

IS-95 Only mode. These commands set/query the time offset measurement of the code domain analyzer.

This measurement utilizes the Number Measurement Syntax, but does not use the :METer command.

Syntax

MEAS:CDAN:TIME:OFFS <meas cmd>

!See “Number Measurement Syntax” on page 283. MEAS:CDAN:TIME:OFFS?

Example

MEAS:CDAN:TIME:OFFS? !displays the measurement

Screen/field equivalent

MEAS:CDAN:TIME:OFFS? reads the Time Ofs measurement field on the CODE DOM screen when the CDMA standard is set to “IS-95 Only”.

:CDANalyzer:TRACe:POWer?

IS-95 Only mode. This command queries the power in each of the 64 Walsh channels, relative to the pilot’s power. (Pilot power is approximately two-thirds of the total power.) The measurement returns 64 values (in dB), one for each point.

Syntax

MEAS:CDAN:TRAC:POW?

Screen/field equivalent

MEAS:CDAN:TRAC:POW? does not correspond to any field on the CODE DOM screen. This applies when the CDMA standard is set to “IS-95 Only”.

232 Chapter 1