3Com Switch 7750 Series
Command Reference Guide – System Maintenance & Debugging Chapter 3 Device Management
Commands
3-10
Description
Use the display uplink monitor command to view information about Layer 3
connectivity between the local device and the remote device.
Related command: uplink monitor.
Example
# View information about Layer 3 connectivity between the local device and the remote
device.
<3Com> display uplink monitor
UpLink monitor information
No. Dest_IP_Addr Dest_MAC_Addr Vlan Port ErrCnt Last_Err_Time
1 192.168.0.35 ----.----.---- 1 - 135 04/29 16:15:04
The above information shows there are 135 Layer 3 connectivity errors between the
local device and the remote device whose IP address is 192.168.0.35.
3.1.14 loadsharing enable Syntax
loadsharing enable
undo loadsharing enable
View
System view
Parameter
None
Description
Use the loadsharing enable command to enable system load sharing.
Use the undo loadsharing enable command to disable system load sharing.
By default, system load sharing function is disabled.
With system load sharing enabled, when an LPU receives traffic to be cross-card
forwarded, load sharing is performed between the active SRPU and the standby SRPU.
Note:
z Only unicast traffic supports load sharing.
z Only LPUs of XGbus type support load sharing.