3Com Switch 7750 Series
Command Reference Guide — IP / IPX Chapter 3 IPX Configuration Commands
3-16
Example
# Set the maximum number of dynamic routes saved in the device to the same
destination to 200.
<3Com>system-view
System View: return to User View with Ctrl+Z.
[3Com] ipx route max-reserve-path 200
3.1.15 ipx route-static Syntax
ipx route-static network network.node [ preference value ] [ tick ticks hop hops ]
undo ipx route-static { network [ network.node ] | all }
View
System view
Parameter
network: Destination network number of an IPX static route. It comprises eight
hexadecimal numbers and is in the range of 1 to 0xFFFFFFFE. IPX static routes
whose destination network number is 0xFFFFFFFE are default routes.
network.node: Next hop address of the IPX static route. network defines the network
number; node defines the node address using 12 hexadecimal numbers that are
separated into three parts using “-“, each part in the range of 1 to 0xFFFF.
preference value: Static route preference in the range of 1 to 255. A smaller value
indicates a higher preference. By default, the preference values of the static routes,
direct routes, and dynamic RIP IPX routes are 60 (user-configurable), 0, and 100.
ticks ticks: Time that a packet must take to reach the destination network, with 1 tick =
1/18 seconds. The value ranges from 1 to 65534. The default value is 1.When the tick
value of a VLAN interface is modified, the tick value of the static route also changes.
You must configure both the tick value and the hop count.
hop hops: Number of the switches on the way to the destination network. It is in the
range 1 to 15 and defaults to 1. You must configure both the hop count and tick value.
all: All the IPX static routes.
Description
Use the ipx route-static command to configure a static IPX route.
Use the undo ipx route-static command to delete the static IPX route.
The IPX static routes whose destination network number is 0xFFFFFFFE are default
routes.