3Com Switch 7750 Series
Command Reference Guide — Link Aggregation Chapter 1 Link Aggregation Configuration Commands
1-2
View
Any view
Parameter
interface interface-type interface-number [ to interface-type interface-number ]:
Specifies a port range.
z If the to keyword is not specified, only one port is specified;
z If the to keyword is specified, multiple contiguous ports are specified;
z The interface-type argument represents the port type and the interface-num
argument represents the port number.
Description
Use the display link-aggregation interface command to display the link aggregation
details about a specified port or port range, including:
z Link aggregation group ID of the specified port or port range
z Port priority, operation key and LACP status flag of the local end,
z Device ID, port number, port priority, operation key and protocol status flag and
LACP packet statistics of the remote end
Note that, for a manual aggregation group, value 0 is displayed for all the above items
of the remote end (which does not indicate the real information of the remote end),
since information about the remote end cannot be obtained for a manual aggregation
group.
Example
# Display the link aggregation details on the specified port.
<3Com> display link-aggregation interface ethernet1/0/1
Ethernet1/0/1:
Attached AggID: 20
Local:
Port-Priority: 32768, Oper key: 2, Flag: 0x3d
Remote:
System ID: 0x8000, 000e-84a6-fb00
Port Number: 2, Port-Priority: 32768 , Oper-key: 10, Flag: 0x3d
Received LACP Packets: 8 packet(s), Illegal: 0 packet(s)
Sent LACP Packets: 9 packet(s)