3Com 7750 Series Chapter 1 Static Route Configuration Commands

3Com Switch 7750 Series

Command Reference Guide – Routing Protocol Chapter 1 Static Route Configuration Commands

1-1

Chapter 1 Static Route Configuration Commands

 Note:

The words “router” covered in the following text represent routers in common sense

and Ethernet switches running a routing protocol. To improve readability, this will not

be mentioned again in this manual.

Syntax

display ip routing-table

View

Any view

Parameter

None

Description

Use the display ip routing-table command to display the routing table summary.

This command displays the summary of the routing table. Each line represents one

route, containing destination address/mask length, protocol, preference, cost, next

hop, and output interface.

This command displays only the currently used routes, that is, the optimal routes.

Example

# Display the summary of the current routing table.

<3Com> display ip routing-table

Routing Table: public net

Destination/Mask Protocol Pre Cost Nexthop Interface

1.1.1.0/24 DIRECT 0 0 1.1.1.1 Vlan-interface1

1.1.1.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0

2.2.2.0/24 DIRECT 0 0 2.2.2.1 Vlan-interface2