3Com Switch 7750 Series
Command Reference Guide – Routing Protocol Chapter 6 IP Routing Policy Configuration Commands
6-10
Field Description
if-match
(prefixlist) p1 if-match statement configured
apply cost 100 Apply routing cost 100 to the routes matching
the conditions defined by if-match statement
matched Number of routes matching the conditions set by
if-match statement
denied Number of routes not matching the conditions
set by if-match statement
Syntax
if-match { acl acl-number | ip-prefix ip-prefix-name }
undo if-match { acl | ip-prefix }
View
Route policy view
Parameter
acl-number: Number of the ACL used for filter
ip-prefix-name: Name of the prefix address list used for filter, containing 1 to 19
characters.
Description
Use the if-match { acl | ip-prefix } command to configure a rule for the route-policy
and specify an matching IP address range.
Use the undo if-match { acl | ip-prefix } command to cancel the setting of the rule.
The if-match { acl | ip-prefix } command implements a filter by referencing an ACL or
a prefix address list.
Related command: if-match interface, if-match ip next-hop, if-match cost,
if-match tag, route-policy, apply ip next-hop, apply cost, apply local-preference,
apply origin, and apply tag.
Example
# Define an if-match statement. When the statement is used for filtering route
information, the route information filtered by route destination address through
address prefix list p1 is permitted to pass the if-match statement.
<3Com> system-view