3Com Switch 7750 Series
Command Reference Guide — Basic Port Commands Chapter 1 Port Basic Configuration Commands
1-14
rates in the interval. For example, if you set the interval to 100 seconds, the displayed
information is as follows:
Last 100 seconds input: 0 packets/sec 0 bytes/sec
Last 100 seconds output: 0 packets/sec 0 bytes/sec
Related command: display interface.
Example
# Set the interval to perform statistics on the Ethernet1/0/1 port to 100 seconds.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] interface ethernet 1/0/1
[3Com-Ethernet1/0/1] flow-interval 100
1.1.13 hardspeedup Syntax
hardspeedup enable
hardspeedup disable
View
System view
Parameter
None
Description
Use the hardspeedup enable command to enable command to enable the hardware
speedup function inside the port.
Use the hardspeedup disable command to disable the hardware speedup function
inside the port.
By default, the hardware speedup function inside the port is enabled.
Note:
z The commands above are applicable to type-A LPUs only, including 3C16860,
3C16861, 3C16858, and 3C16859.
z The commands above are diagnostic, so you cannot use them at discretion.
Example
# Enable the hardware speedup function inside the port.