3Com Switch 7750 Series
Command Reference Guide – Routing Protocol Chapter 1 Static Route Configuration Commands
1-7
Age: 3:47 Cost: 0/0 Tag: 0
# There is no corresponding route in the natural mask range (only the longest
matched route is displayed). Display the detailed information.
<3Com> display ip routing-table 169.253.0.0 verbose
Routing Tables:
Generate Default: no
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Summary count:1
**Destination: 169.0.0.0 Mask: 255.0.0.0
Protocol: #Static Preference: 60
*NextHop: 2.1.1.1 Interface: 2.1.1.1(LoopBack1)
Vlinkindex: 0
State: <Int ActiveU Static Unicast>
Age: 3:47 Cost: 0/0 Tag: 0
For detailed description of the output information, see Table 1-2.
1.1.4 display ip routing-table ip-address1 ip-address2 Syntax
display ip routing-table ip-address1 mask1 ip-address2 mask2 [ verbose ]
View
Any view
Parameter
ip-address1, ip-address2: Destination IP address in dotted decimal notation.
ip-address1, mask1 and ip-address2, mask2 determine one address range
together. .ip-address1 ANDed with mask1 specifies the start of the range, while
ip-address2 ANDed with mask2 specifies the end. This command displays the route
in this address range.
mask1, mask2: IP address mask, length in dotted decimal notation or expressed as
an integer. It ranges from 0 to 32 when expressed as an integer.
verbose: With the verbose argument provided, this command displays the verbose
information of both active and inactive routes. Without this argument provided, this
command displays the summary of active routes only.
Description
Use the display ip routing-table ip-address1 ip-address2 command to display the
route information in the specified destination address range.