3Com Switch 7750 Series
Command Reference Guide – Routing Protocol Chapter 2 RIP Configuration Commands
2-18
Example
# Specify the interface Vlan-interface 10 not to use split horizon when processing RIP
packets.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] interface Vlan-interface 10
[3Com-Vlan-interface10] undo rip split-horizon
2.1.20 rip version Syntax
rip version { 1 | 2 [ broadcast | multicast ] }
undo rip version
View
Interface view
Parameter
1: Specifies the version of RIP packets on the interface to RIP-1.
2: Specifies the version of RIP packets on the interface to RIP-2.
broadcast: Transmission mode of RIP-2 packets is broadcast.
multicast: Transmission mode of RIP-2 packets is multicast.
Description
Use the rip version command to specify the version of RIP packets on an interface.
Use the undo rip version command to restore the default RIP packet version on the
interface.
By default, the interface RIP version is RIP-1. RIP-1 transmits packets in broadcast
mode, while RIP-2 transmits packets in multicast mode by default.
When running RIP-1, the interface only receives and transmits RIP-1 broadcast
packets, and receives RIP-2 broadcast packets, but does not receive RIP-2 multicast
packets. When running RIP-2 in broadcast mode, the interface receives and transmits
RIP-2 broadcast packets, receives RIP-1 broadcast packets and RIP-2 multicast
packets. When running RIP-2 in multicast mode, the interface only receives and
transmits RIP-2 multicast packets, receives RIP-2 broadcast packets, but does not
receive RIP-1 broadcast packets.
Example
# Configure the interface Vlan-interface 10 as RIP-2 broadcast mode.
<3Com> system-view