3Com Switch 7750 Series
Command Reference Guide β Mirroring Chapter 1 Mirroring Commands
1-13
current VLAN is a dynamic VLAN or not. If it is a dynamic VLAN , the command fails to
be executed, and the system prompts that βCan not set dynamic VLAN as
remote-probe VLAN!β.
Use the undo remote-probe vlan enable command to configure the remote-probe
VLAN as a normal VLAN.
Before configuring the remote-probe VLAN, make sure that no Access or Hybrid port
belongs to this VLAN. If any Trunk port exists in this VLAN, the port PVID cannot be the
ID of remote-probe VLAN. After setting a VLAN as remote-probe VLAN, it is
recommended that you do not add Access or Hybrid port to the VLAN.
ξ Note:
The undo vlan all command cannot be used to remove the specified remote-probe
VLAN.
Example
# Configure VLAN 5 as remote-probe vlan.
<3Com> system-view
System View: return to User View with Ctrl+Z.
[3Com] vlan 5
[3Com-vlan5] remote-probe vlan enable