3Com Switch 7750 Series
Command Reference Guide – AAA, RADIUS, HWTACACS, EAD Chapter 1 AAA & RADIUS & HWTACACS
Configuration Commands
1-10
Therefore, it is necessary to distinguish between them by setting ISP domains. You can
configure a complete set of independent ISP domain attributes, including AAA schemes
(such as the RADIUS scheme used), for each ISP domain in ISP domain view.
For the switch, each access user belongs to an ISP domain.
You can configure up to 16 ISP domains in the system. If the specified ISP domain does
not exist when you issue this command, the system creates a new ISP domain. An ISP
domain is active immediately after being created.
Related command: access-limit, scheme, state, display domain
Example
# Create an ISP domain named aabbcc.net and enter its view.
[3Com] domain aabbcc.net
New Domain added.
[3Com-isp-aabbcc.net]
1.1.8 idle-cut Syntax
dle-cut { disable | enable minute flow }
View
ISP domain view
Parameter
disable: Inhibits users from enabling the idle-cut function.
enable: Allows users to enable the idle-cut function.
minute: Maximum idle time, ranging from 1 minute to 120 minutes.
flow: Minimum data flow, ranging from 1 byte to 10,240,000 bytes (10 M).
Description
Use the idle-cut command to set the user idle-cut function in current ISP domain.
By default, this function is disabled.
A user template is a set of default user attributes. If a user requesting for a network
service does not possess a required attribute, the attribute in a user template is used as
the user's default attribute. If neither the user nor the RADIUS server specifies whether
its idle-cut function is enabled, the idle-cut function state of the user template is
specified as that of the user.
A user template applies to only one ISP domain. Therefore, you need to configure
different user template attributes for users in different ISP domains.