NEC 750370 manual 9721234567

Issue 3 EliteMail VMS/EliteMail Limited

8.Add an additional Phone Book entry for each host computer you plan to call. To do this, repeat step 4 through step 7.

9.When you finish, press ￿￿￿￿￿repeatedly to exit.

SAMPLE PHONE NUMBER FORMAT: 9,9721234567,,,,987

EXAMPLE MEANING

9The number used to dial out. For NEC telephone systems, this is 9.

,Inserts a two-second delay.

9721234567	The number dialed. In this example, 972 is the area code,
	1234567 the phone number.
,,,,987	Adds a delay before dialing an extension. Four or five commas
	add an 8- to 10-second pause prior to dialing 987.
	Figure 2-6 Sample Phone Number Format

SECTION 4

SET THE HOST MODEM The serial interface on the EliteMail VMS/EliteMail Limited ETU has a 9- pin RS-232 connector for direct connection to the Remote Maintenance computer, and an RJ-11 serial port for remote connection by modem. The interface designation is COM2. Switch SW1, located on the interface, is a 4-position DIP switch that controls the active connection according to Table 1-1 SW1 Settings.

Table 1-1 SW1 Settings

1Normally off.

2Normally off. When 1 and 2 are both on, the VM application stops working (Maintenance Mode)

3On – COM2 Remote (RJ11) Connection Off – COM1 Local Connection

4Maintenance Use

2 - 8 Install the Remote Computer Software