NEC 750370 manual Section DIAL-OUT Access, Section Special Telephone System Settings

Issue 3	￿	EliteMail VMS/EliteMail Limited
		SKT=n, n
		This option controls softkey timeout. Two separate timers are used.
		The first timer controls the time that the softkeys are displayed when
		first calling in to voice mail. If softkeys are not pressed, the system
		changes to normal conversation mode after this timer expires. The
		second timer controls the time before moving back one menu if
		softkeys are not pressed.
SECTION 2
DIAL-OUT ACCESS	This code controls dial-out access. Refer to Chapter 21 Switch Setup for
	other dial-out settings.
		OTL=n
		Outdial trigger length. By default, the voice mail system considers a
		telephone number to dial an external call if it has more than 5
		characters (including any special dialing characters). However, if you
		need to change this value, you can do so by adding the outdial trigger
		length option.
		To change the outdial trigger length, enter OTL=n where n equals a
		number between 4 and 15 (e.g., enter OTL=11). In this example, the
		system considers telephone numbers with 11 or fewer characters as
		internal extension numbers, and longer telephone numbers are
		considered external calls.
SECTION 3
SPECIAL TELEPHONE
SYSTEM SETTINGS	￿	TM

Trunk mapping routes trunk calls to specific message boxes.

The format is TMn-m=ID where n is the first trunk number in a group, m is the last trunk number in the group, and ID is the System ID that receives calls from that trunk group. For example, TM1-6=206 specifies routes calls on trunks 1 through 6 to box number 206. You may specify multiple TM options to route different trunk groups to different message boxes.

Trunks must be programmed to ring directly to the voice mail system ports to use this feature. (Otherwise the trunk identification DTMF codes are not sent to the voice mail system.)

No check is made on the validity of the System ID specified when you enter it at the voice mail system screen. If an invalid System ID is specified for a given trunk, the voice mail system pauses 5 seconds, then says “I’m sorry. I did not hear your selection. Please reenter your selection now.”

F - 2 Integration Option Codes