Tektronix DPO4000, MSO4000 DESkew:DISPlay, DIAg:LOOP:OPTion, DIAg:LOOP:OPTion:NTIMes

Commands Listed in Alphabetical Order
DESkew:DISPlay
Sets or returns the state of the deskew table display.
Group Vertical
Syntax DESkew:DISPlay {OFF|ON|0|1}
DESkew:DISPlay?
Arguments OFF or 0 turns off the deskew table display.
ON or 1 turns on the deskew table display.
DIAg:LOOP:OPTion
Sets the self-test loop option.
Group Calibration and Diagnostic
Syntax DIAg:LOOP:OPTion {ALWAYS|FAIL|ONFAIL|ONCE|NTIMES}
Arguments ALWAYS continues looping until the self tests (diagnostics) are stopped via the
front panel or by an oscilloscope command.
FAIL causes looping until the first self test (diagnostic) failure or until self tests
(diagnostics) are stopped.
ONFAIL causes looping on a specific test group as long as a FAIL status is
returned from the test.
ONCE executes self test (diagnostics test) sequence once.
NTIMES runs “n” number of loops.
Examples DIAG:LOOP:OPTION ONCE runs one loop of self tests.
DIAg:LOOP:OPTion:NTIMes
Sets the self-test loop option to run N times.
Group Calibration and Diagnostic
2-154 MSO4000 and DPO4000 Series Programmer Manual