Commands Listed in Alphabetical Order
TRIGGER:A:BUS:B1:FLEXRAY:HEADER:PAYLENGTH? might return
TRIGGER:A:BUS:B1:FLEXRAY:HEADER:PAYLENGTH "XXXXXXX" indicating
the FLEXRAY header paylength is don’t care.
TRIGger:A:BUS:B<x>:I2C:ADDRess:MODe
Sets or returns the I2C address mode to 7 or 10-bit. Applies to bus <x>, where x
is the bus number.
Conditions This command requires a DPO4EMBD application module.
Group Trigger
Syntax TRIGger:A:BUS:B<x>:I2C:ADDRess:MODe {ADDR7|ADDR10}
TRIGger:A:BUS:B<x>:I2C:ADDRess:MODe?
Arguments ADDR7 specifies the 7-bit I2C address mode.
ADDR10 specifies the 10-bit I2Caddressmode.
Examples TRIGGER:A:BUS:B1:I2C:ADDRESS:MODE ADDR10 sets the I2C address mode
to 10-bit.
TRIGger:A:BUS:B<x>:I2C:ADDRess:TYPe
Sets or returns the I2C address type. The only supported address type is USER.
Applies to bus <x>, where x is the bus number.
Conditions This command requires a DPO4EMBD application module.
Group Trigger
Syntax TRIGger:A:BUS:B<x>:I2C:ADDRess:TYPe
{GENeralcall|STARtbyte|HSmode|EEPROM|USER}
TRIGger:A:BUS:B<x>:I2C:ADDRess:TYPe?
Arguments GENeralcall specifies a general call address.
STARtbyte specifies a start byte address.
MSO4000 and DPO4000 Series Programmer Manual 2-413