Tektronix DPO4000, MSO4000 BUS:B<x>:CAN:PRObe, BUS:B<x>:CAN:SAMPLEpoint, BUS:B<x>:CAN:SOUrce

Commands Listed in Alphabetical Order
BUS:B<x>:CAN:PRObe
Sets or returns the probing method to probe CAN bus <x>, where x is the bus
number.
Conditions This command requires a DPO4AUTO application module.
Group Bus
Syntax BUS:B<x>:CAN:PRObe {CANH|CANL|RX|TX|DIFFerential}
BUS:B<x>:CAN:PRObe?
Arguments CANH specifies the single-ended CANH signal, as specified by the CAN standard.
CANL specifies the single-ended CANL signal, as specified by the CAN standard.
RX specifies the receive signal on the bus side of the CAN transceiver.
TX specifies the transmit signal.
DIFFerential specifies the differential CAN signal.
BUS:B<x>:CAN:SAMPLEpoint
Sets or returns the sampling point during each bit period for bus <x>, where x
is the bus number
Conditions This command requires a DPO4AUTO application module.
Group Bus
Syntax BUS:B<x>:CAN:SAMPLEpoint <NR1>
BUS:B<x>:CAN:SAMPLEpoint?
Arguments <NR1> is the sample point in percent. Values are limited to 25, 30, ... 70, 75.
BUS:B<x>:CAN:SOUrce
Sets or returns the CAN bus data source for bus <x>, where x is the bus number.
Conditions This command requires a DPO4AUTO application module.
2-92 MSO4000 and DPO4000 Series Programmer Manual