Getting Started
This manual explains the use of commands for remotely controlling your
oscilloscope. With this information, you can write computer programs to
perform functions, such as setting the front-panel controls, taking measurements,
performing statistical calculations, and exporting data for use in other programs.

Setting Up Remote Communications

You can remotely communicate between your oscilloscope and PC via the
Ethernet, USB, and, GPIB using the TEK-USB-488 Adapter.
Ethernet If you are using Ethernet, start by connecting an appropriate Ethernet cable to the
Ethernet port (RJ-45 connector) on the rear panel of your oscilloscope. This
connects the oscilloscope to a 10/100 Base-T local area network.
To change the Ethernet settings on your oscilloscope,do the following:
1. On the front panel, push Utility.
2. Push Utility Page.
3. Select I/O with the Multipurpose knob.
4. Push Ethernet Network Settings.
5. On the side-bezel menu, if you are on a DHCP Ethernet network and using a
through cable, set DHCP/BOOTP to On.
6. If you are using a cross-over cable, set DHCP/BOOTP to Off, and set a hard
coded TCPIP address.
USB If you are using USB, start by connecting an appropriate USB cable to the USB
2.0 high-speed device port on the rear panel of your oscilloscope.
MSO4000 and DPO4000 Series Programmer Manual 1-1