adjunct routing

NOTE:

Actually, other than to another goto step, the first step to which a goto step is usually designed to branch is a nontreatment step (that is, a step containing a command other than a wait-timeor an announcement command). Thus, the skipping of a treatment step according to the scenario described just before this note rarely occurs.

On the other hand, if the goto step fails, the switch skips any announcement or wait-timestep that immediately follows the goto step.

NOTE:

The goto step that fails can be at the end of a sequence of goto steps that branch to each other.

After the switch sends a route request to the ASAI adjunct, vector processing continues with the vector steps that follow.

The step that follows the adjunct routing step, in effect, determines the maximum length of time the switch will wait for the ASAI adjunct to reply with a call route. Accordingly, you should always include either a wait-timestep or an announcement step immediately after an adjunct routing step. Moreover, the switch cancels the route request if vector processing encounters a step containing one of the commands that follow:

adjunct routing

busy

check-backup split

collect digits

converse-on split

disconnect

messaging split

queue-to main split

route-to

NOTE:

Actually, if another adjunct routing step is encountered, the route request information is not lost. Although the initial route request is cancelled, a second route request is sent, and this route request includes the same information included in the first route request.

If a valid call route is received by the switch before one of the vector commands in the previous list is executed, the switch routes the call to the destination specified by the adjunct route. Otherwise, the route request is terminated without affecting vector processing.

Issue 4 September 1995 A-17

Page 224
Image 224
AT&T 555-230-520 manual