AT&T 555-230-520 manual Table A-8. Vectoring Commands Generic 3 Version

Command Job Aid

7.Even numbers only.

8.Active means the called VDN as changed by VDN override. Latest means the VDN assigned to the vector in which the call is currently being processed.

9.The Call Prompting feature must be enabled.

Table A-8. Vectoring Commands — Generic 3 Version 4 (continued)

goto step1 ____ if	expected-wait2call		_____	_____
(1-32)	for		(<, <=)3	(1-9999)
			(>, >=, <>, =)	(0-9999)
	ii-digits4	_____	table	_____
		(in, not-in)		(1-5 [G3vs/s])
				(1-10 [G3i])
				(1-100 [G3r])
	ii-digits4	_____	_____
		(<, >, <=, >=)	(00-99)
		(<>, =)	[00-99, +, +?, ?+, ??, ?x (where x = 0-9), x?, none]5
	oldest-call-wait ______		pri __	_____	_____
	in split	(1-24 [G3vs/s])	(low, med,	(<, <=)	(2-998)6
		1-99 [G3i])	high, top)	(>, >=, <>, =)	(0-998)6
		(1-255 [G3r])
	staffed-agents	_____	_____	_____
	in split	(1-24 [G3vs/s])	(<, <=)	(1-150 [G3vs/s], 1-200 [G3i],, 1-999 [G3r])
		(1-99 [G3i])	(>, >=, <>, =)	(0-149 [G3vs/s], 0-199 [G3i], 0-998 [G3r])
		1-255 [G3r])
	time-of-day is	_____	_____ to	_____	_____
		(mon, tue,	(hh:mm in	(mon, tue,	(hh:mm in military
		wed, thu, fri,	military time)	wed, thu, fri,	time)
		sat, sun, all)		sat, sun, all)

unconditionally7

1.The “goto vector” command is identical to the “goto step” command, except the word step is replaced by the word vector. The valid values for vector are: 1-48 [G3vs/s], 1-256 [G3i], 1-512 {G3r].

2.The Vectoring (G3V4 Advanced Routing) and Vectoring (G3V4 Enhanced) options must be enabled.

3.The <=, > =, < >, and = comparators are new for G3V4. <= means less than or equal to, >= means greater than or equal to, <> means not equal to, and = means equal to.

4.The Vectoring (ANI/II-Digits Routing) and Vectoring (G3V4 Enhanced) options must be enabled.

5.A ? matches any digit 0-9 in that single digit position. A + matches any or no characters.

6.Even numbers only.

7.This command is also available with Call Prompting.

Issue 4 September 1994 A-11