Route-to Number

Differences in Command Function

This command routes the call to a specific number.

Table E-3. G2/G3 Differences for Route-to Number Command

GENERIC 3	GENERIC 2
The actual digit string is used as the	The AD member number is used as
destination. The string can contain	the destination. None of the special
special characters that may be	characters may be used. The special
stored in an AD string, including ~p,	functions are handled by the
~w, ~W, ~m, and ~s (but not * or #).	AAR/ARS pattern routing.
(See the route-to number command
in the manual pages of Appendix A.)
Feature access codes (AAR/ARS) or
trunk access codes may be used to
route calls externally.
The trunk may be accessed via	AAR/ARS is required for non-DCS
ARS/AAR, TAC, or UDP.	trunk calls.
Routing to individual attendant	The individual attendant extension
extensions is permitted.	feature is not available.
Routing to announcement extensions	The announcement command is
is permitted.	required for all announcement
	access.
If the command fails, and if the	If the command is the last step in the
command is the last step in the	vector, a busy destination targeted
vector, the command is not retried. If	by the command is retried every two
retrying is required, an unconditional	seconds.
goto step can be used to loop back
to the route to step.
Routing to an ACD split extension is	This capability is not provided.
allowed even if Call Vectoring is
operational.
Routing to a Service Observing FAC	This capability is not provided.
is allowed

Issue 4 September 1995 E-5