Cisco Systems 4 Using an Ethernet Flow Point

11-8
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 11 Using Cisco PathTracer to Diagnose Problems
Launching Path Tracer
• Using a Pseudowire, page 11-12
• Using an MPLS-TP Tunnel Endpoint, page 11-13
Using an Ethernet Flow Point
A network VLAN is required for you to start a path trace using an Ethernet flow point.
To launch a path trace from an Ethernet flow point:
Step 1 In the Cisco Prime Network Vision navigation pane or map pane, expand the required network VLAN.
Step 2 In the VLAN, right-click the required Ethernet flow point and choose PathTracer > From Here to
Destination. The Path Information dialog box is displayed as shown in Figure 1 1-2 .
Figure 11-2 Ethernet Flow Point Path Trace Launch Point
Step 3 Specify the destination using the information in Table 11-4.
Step 4 To limit the number of hops for the path trace, check the Stop trace after check box, and enter the
maximum number of hops for the path trace.
Step 5 Click OK. The Cisco PathTracer window is displayed with the resulting path trace.