20-54
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 20 Monitoring MToP Services
Configuring SONET
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the creden tial s, clic k E dit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Command Navigation Description
BER Threshold Right-click on SONET port and
select Commands > SONET >
Show >
Performed from command launch point
Controller Data
TCA Threshold
SDH Counters Clear > SONET > N/A; performed from command launch
point
BER Threshold Right-click on SONET port and
select Commands > SONET >
Configure >
BER threshold:
• sf-ber—Sets the signal failure BER
threshold. Value in the range from
3 to 9. The default value is 6
• sd-ber—Sets the signal degrade
BER threshold. Value in the range
from 3 through 9. The default value
is 3
Bit error rate: 3-9, or default. The
default for sf-ber is 3, and the default
for sd-ber is 9.
Line Counters Right-click on SONET port and
select Commands > SONET >
Show > PM
Line type: farendline,
farendline-history, line, or line-history
History interval: 1-96; to view all, enter
0
Medium Counters N/A; performed from command launch
point
Path type: farendpath,
farendpath-history, path, path-history
Path Counters Channelized path index: 1-48 (for a
particular channel) or 0 (for all
channels)
History interval: 1-96; to view all, enter
0
Section Counters Right-click on SONET port and
select Commands > SONET >
Show > PM
Section type: section or section-history
History interval: 1-96; to view all, enter
0
Trace Details Card location (for example, 0/5/CPU0)
Note The device must be managed by
Prime Network with device
admin privileges.