25-129
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies Working with Active Charging Service
Service ID Configured service ID used to associate the charging action in rule
definitions configuration.
Charging EDR Name Name of the EDR format for the billing action in the ACS.
EGCDRs Indicates whether eG-CDRs must be generated when the subscriber session
ends or an interim trigger condition occurs.
Rf Indicates whether Rf accounting is enabled or not.
UDRs Indicates whether UDRs must be generated based on the UDR forma t
declared in the rule base.
Flow Idle Timeout Maximum duration a flow can remain idle after which the system
automatically terminates the flow.
Limit for Flow Type
State Indicates whether the limit for flow type is configured or not.
Limit for Flow Type
Valu e Maximum number of flows of a particular type.
Limit for Flow Type
Action Action to be taken, if the number of flows exceeds the maximum limit.
IP Type of Service IP Type of Service (ToS) octets used in the charging action.
Retransmission Count Indicates whether to count the number of packet retransmissions when the
charging action is applied on the incoming data packets.
Content Filtering Indicates whether content filtering must be applied on the incoming packets
or not.
Credit Control Indicates whether to apply credit control or not.
Credit Rating Group Coupon ID used in prepaid charging as rating group.
Charge Volume Method used for charge volume calculation based on the protocol an d
packet.
Next Hop Forwarding
Address Next hop forwarding address for a charging action.
VLAN ID VLAN ID configured for the subscriber
Flow Mapping Idle
Timeout Maximum duration, in seconds, a flow can remain idle after which the
system automatically terminates the flow.
Allocation Retention Priority
Priority Level Priority value that indicates whether to accept or reject a request for
establishment or modification of a bearer in a limited resource condition.
Priority Vulnerability
Indicator Defines whether an active bearer can be preempted by a p reemption-capable
high priority bearer.
Priority Capability
Indicator Defines whether the bearer request can preempt the resources from th e Low
Priority Pre-empatable Active Bearers.
Bandwidth
Bandwidth ID The bandwidth policy ID for the ACS.
Uplink Indicates whether uplink flow limit is configured for the subscriber or not.
Table 25-78 Charging Action Properties in Logical Inventory (continued)
Field Description