18-55
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 18 Monitoring MPLS Services Configuring MPLS-TP
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the creden tial s, clic k E dit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Keep the following in mind:
• LSP Path Lockout can be accessed at both the tunnel level and endpoint level. If you run the
command at the tunnel level, you must indicate whether the L sp i s pr otec ted o r worki ng.
• To run the Global Configuration, BFD Configuration, and Link Configuration commands o n th e
Cisco Carrier Packet Transport (CPT) System, right-click the device in the Prime Network Vision
List or Map View, and click Logical Inventory > CPT Context Container.
Command Description
Tunnel Ping
Tunnel Trace
LSP Ping
LSP Trace
LSP Lockout
LSP Path Lockout
LSP Path No Lockout
These actions are performed at the command the launch
point.
Add Global Configuration
Update Global Configuration
Remove Global Configuration
Configure Global configuration with Router-id, Global-id,
Fault OAM refresh timer value, Wait before restoring timer
value.
The remove operation is performed at the command the
launch point.
BFD Global Configuration BFD minimum interval and multiplier.
Note Only supported on Cisco ASR 9000.
Add Link Configuration Remove Link
Configuration MPLS-TP link number, Next hop router address. Only the
link number is require for the remove operation.
Add BFD Template Configuration
Remove BFD Template Configuration
Template type and name, interval type and value, For
compute hold down Check/UnCheck Multiplier, multiplier
value.
The remove operation requires a template type and name.
Show BFD Template
Show BFD Template at Tunnel
Show BFD Template requires a template name. The Show
BFD Template at Tunnel is performed at the command
launch point.
Add Label Range Configuration
Remove Label Range Configuration
Minimum and maximum values for dynamic and static
labels. The remove operation is performed at the command
the launch point.
Note Not supported on Cisco IOS.