21-14
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 21 Viewing and Managing SBCs
Configuring SBC Components
Configuring SBC Components
The following commands can be launched from the logical inventory by right-c licki ng t he Sessi on
Border Controller node. Before executing any commands, you can preview them and view the results. If
desired, you can also schedule the commands.
The table below lists the SBC components configuration commands. Additional commands may be
available for your devices. New commands are often provided in Prime Network Device Packages,
which can be downloaded from the Prime Network software download site. For more information on
how to download and install DPs and enable new commands, see the information on “Adding Additional
Device (VNE) support” in the Cisco Prime Network 4.0 Administrator Guide.
For details on the software versions Prime Network supports for the listed supported network elements,
see Cisco Prime Network 4.0 Supported Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the creden tial s, clic k E dit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
You can configure the following SBC components using the commands described in this section.
Command Navigation Description
Current 15 Min Statistics Show > PM > Based on the command selected, the
device’s statistics are displayed.
Current 5 Min Statistics
Current Day Statistics
Current Hour Statistics
H.248 Statistics
Previous 15 Minutes Statistics
Previous 5 Minutes Statistics
Previous Day Statistics
Previous Hour Statistics
CPS Data
Media Statistics Show >
Components
Command Navigation Description
SIP Adjancencies