14-9
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 14 Monitoring DWDM Properties Viewing G.709 Properties
Step 4 To view additional G.709 properties, click the required tab. Table 14-5 describes the information
displayed in each tab. The information that is displayed depends on the selected network element.
OTU Alerts
OTU Alert Reporting
Enabled for The types of alerts enabled for reporting:
• SD-BER—Section Monitoring (SM) bit error rate (BER) is in excess
of the signal degradation (SD) BER threshold.
• SF-BER—SM BER is in excess of the signal failure (SF) BER
threshold.
• PM-TCA—Performance monitoring (PM) threshold crossing aler t
(TCA).
• SM-TCA—SM threshold crossing alert.
OTU Asserted Alerts OTU alerts indicated to be reported by the user.
OTU Detected Alerts OTU alerts detected by the hardware.
ODU Alerts
ODU Alert Reporting
Enabled for The types of ODU alerts enabled for reporting:
• SD-BER—SM BER is in excess of the SD BER threshold.
• SF-BER—SM BER is in excess of the SF BER threshold.
• PM-TCA—PM threshold crossing alert.
• SM-TCA—SM threshold crossing alert.
ODU Asserted Alerts ODU alerts indicated to be reported by the user.
ODU Detected Alerts ODU alerts detected by the hardware.
Other
FEC Info FEC properties:
• FEC mode for the controller—Disable, Enhanced, Standard, or
Unknown.
• Remote FEC mode—FEC mode on the remote device: Disabled,
Enhanced, Standard, or Unknown.
• FEC mismatch counter—Number of sync word mismatches found
during the tracking phase.
Status G.709 wrapper administrative status: Up or Down.
Table 14-5 G709 Properties Window Tabs
Field Description
OTU Alarm Counters Tab
Type Type of OTU alarm, such as BDI or BEI.
Counter Number of alarms reported for each alarm type.
Table 14-4 DWDM G709 Properties Window (continued)
Field Description