20-58
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 20 Monitoring MToP Services
Configuring TDM and Channelization
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the creden tial s, clic k E dit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Command Navigation Description
TDM Commands
Configure Card Type Right-click the device >
Commands > Configuration > • For ASR9000, configure the card
type as SONET/SDH an specify the
chassis, slot or the subslot number.
• For ASR 903 and 901, configure
the card type as E1, T1, and specify
the location using slot and bay
number.
Modify E1 Controller
Modify T1 Controller
(For ASR901, ASR903):
Physical Inventory > Chassis
> Slot > right-click on E1 or T1 >
Commands > Configuration >
E1T1 >
or
(For ASR9000, ASR903):
Physical Inventory > Chassis >
Slot > click on SONET >
double-click on a SONET/SDH
High Order Path (HOP) >
right-click LOP > Commands >
Configuration > E1T1 >
• In ASR 9000, E1 and T1 controller
is configured as part of the
channelization, when configuring
the low order path (LOP) for the
SONET controller.
• For ASR 903, you can configure E1
or T1 controller in either of the
following ways:
–
While configuring the card
type
or
–
During the channelization
when configuring the low order
path (LOP) for the SONET.
• For ASR 901, configure the card
type to configure E1 or T1
controller.
Channelization Commands for SONET/SDH
Note Channelization commands also include the TDM commands discussed above. Read the
description to understand the scenario applicable to y our d evice.
Configure Framing
Configure AUG
Mapping
Physical Inventory > Chassis >
Slot > Subslot > right-click on
SONET/SDH-interface >
Commands > Configuration >
SONET >
Configure SDH/SONET framing type
using this command.
Configuring framing as SDH,
configures AU4 by default, but if you
want to change the mode of operation as
AU3, use the AUG Mapping command.