20-47
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 20 Monitoring MToP Services Network Clock Service Overview
SyncE Interfaces Table
Interface Name Name of the Gigabit or 10 Gigabit interface associated with SyncE.
If SyncE is not associated with a Gigabit or 10 Gigabit interface, this
field contains Internal.
Interface Hyperlinked entry to the interface routing information in the Routing
Entity Controller window. For more information, see Viewing Routing
Entities, page 18-31.
This field does not apply for Internal interfaces.
Mode Whether the interface is enabled or disabled for the QL function:
QL-Enabled or QL-Disabled.
Timing Port Priority Value used for selecting a SyncE interface for cl ocking i f more th an one
interface is configured. Values are from 1 to 250, with 1 being the
highest priority.
QL Tx Actual Actual type of outgoing quality level information, depending on the
globally configured SSM option:
ITU-T Option I—Available values are QL-PRC, QL-SSU-A,
QL-SSU-B, QL-SEC, and QL-DNU.
ITU-T Option II Generation 1—Available values are QL-PRS,
QL-STU, QL-ST2, QL-SMC, QL-ST4, and QL-DUS.
ITU-T Option II Generation 2—Available values are QL-PRS,
QL-STU, QL-ST2, QL-TNC, QL-ST3, QL-SMC, QL-ST4, and
QL-DUS.
QL Tx Configured Configured type of outgoing quality level information, depending on the
globally configured SSM option.
See QL Tx Actual for the available values.
QL Rx Actual Actual type of incoming quality level information, depending on the
globally configured SSM option.
See QL Tx Actual for the available values.
QL Rx Configured Configured type of incoming quality level information, depending on
the globally configured SSM option.
See QL Tx Actual for the available values.
Hold-Off Timer (msecs) Length of time (in milliseconds) to wait after a clock source goes down
before removing the source.
Wait-to-Restore (secs) Length of time (in seconds) to wait after a failure is fixed before the
interface returns to its original st ate .
Table 20-25 SyncE Properties (continued)
Field Description