25-68
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies
LTE Networks
Force UDP Tunnel Indicates whether HA would accept requests when Network Address
Translation (NAT) is not detected but the Force bit is set in the Registration
Request (RRQ) with the UDP Tunnel Request.
Simultaneous Bindings The maximum number of care of addresses that can be simultaneously bound
for the same user identified by Network Access Identifier (NAI) and Home
address.
Destination Context The name of the context to assign to the subscriber, after authentication.
A11 Signalling Packets
IP Header DSCP The Differential Services Code Point (DSCP) value in the IP header.
Registration Life Time The registration lifetime configured for all the subscribers to the service.
GRE Encapsulation
Without Key Indicates whether Generic Routing Encapsulation (GRE) without
encapsulation key is used during Mobile IP sessions with FA.
Idle Time Out The method the HA service uses to determine the time to reset a session idle
timer, which can be any one of the following:
• Aggressive
• Handoff
• Normal
SPI List The Security Parameter Index (SPI) between the HA service and the FA.
Optimize Tunnel
Reassembly Indicates whether the option to optimize tunne l r ea ssemb ly is en ab led.
Wi-Max 3GPP Indicates whether the Worldwide Interoperability for Microwave Acces
(Wi-Max)-3GPP option is enabled for the Home agent service.
Setup Time Out The maximum time (in seconds) allowed for session setup.
Reverse Tunnel Indicates whether reverse tunnel feature is enabled for the home agent
feature.
Note A reverse tunnel is a tunnel that starts at the care-of address of the
mobile node and terminates at the home agent. A mobile node can
request a reverse tunnel between the foreign agent and the home
agent when the mobile node registers.
Min. Life Time The minimu m registr ation li fe ti m e for a mo bile I P sessi on.
GRE Encapsulation
With Key Indicates whether GRE is used during mobile IP sessions with an FA.
FA HA SPIs / MN HA SPIs tab
SPI Number The number to indicate the security context between services.
Remote Address The IP address of the source service.
Hash Algorithm The hash algorithm used between the source and destination services.
Time Stamp Tolerance The acceptable allowable difference in time stamps. If this difference is
exceeded, then the session is rejected.
Replay Protection The replay protection scheme that should be implemented by the se rv ice.
Table 25-39 Home Agent Service Details (continued)
Field Description