18-60
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 18 Monitoring MPLS Services
Configuring VRRP
Configuring VRRP
The Virtual Router Redundancy Protocol (VRRP) feature allows for transparent failover at the first-hop
IP router, enabling a group of routers to form a single virtual router. VRRP Command wi ll be used t o
configure VRRP protocol on Cisco router. These commands configures transparent failover at the
first-hop IP router, enabling a group of routers to form a single virt ual rout er.
The table below lists the VRRP configuration commands. Additional commands may be available for
your devices. New commands are often provided in Prime Network Device Packages, which can be
downloaded from the Prime Network software download site. For more informatio n on how to download
and install DPs and enable new commands, see the information on “Adding Additional Device (VNE)
support” in the Cisco Prime Network 4.0 Administrator Guide.
To run the these commands, the software on the network element must suppor t t he t ec hnolo gy. Before
executing any commands, you can preview them and view the results. For details on the software
versions Prime Network supports for the listed supported network elements, see Cisco Prime Network
4.0 Supported Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the creden tial s, clic k E dit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Command Navigation Description1
1. Modify commands can be used to delete specific attributes, whereas the delete commands deletes the complete configuration.
Create BGP Router
Modify BGP Router
Delete BGP Router
MPBGPs > right-click
MPBGP > Commands >
Configuration >
Configures BGP routing and establish
a BGP routing process with AS
number and Router ID
Create BGP Address
Family
Modify BGP Address
Family
Delete BGP Address
Family
Enter various address family
configuration modes that uses IPv4,
IPv6, L2VPN, VPNV4 or VPNV6
address prefixes.
Create BGP Neighbor Places the router in neighbor
configuration mode for BGP routing
and configures the neighbor IP address
as a BGP peer.
Modify BGP Neighbor
Delete BGP Neighbor
MPBGP > MPBGP >
right-click on the BGP
neighbour in the content pane
> Commands >
Configuration >